Home › STEERING › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT STEERING COLUMN ASSEMBLY


    G028400E01
  1. Using SST and a torque wrench, measure the main shaft turning torque.

    SST
    09616-00011  

    Standard turning torque:
    0.4 to 1.1 N*m (4 to 11 kgf*cm, 4 to 10 in.*lb) (2 sec./turn)

  1. If turning torque is out of the specification, remove the motor and remeasure.

    Reference turning torque:
    0.1 to 0.6 N*m (1 to 6 kgf*cm, 1 to 5 in.*lb) (2 sec./turn) (motorless)

    If turning torque is within the specification, replace the motor within a new one.
    If turning torque is out of the specification, replace the steering column assembly with a new one.