Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Steering Angle Sensor Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
STEERING ANGLE SENSOR COMMUNICATION STOP MODE
  1. Steering Angle Sensor is not displayed on "CAN Bus Check" screen of Techstream
  2. Applies to "STEERING ANGLE SENSOR COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside steering angle sensor
  2. Steering angle sensor branch wire and connector

NOTICE:
This detection item is not applicable to a vehicle without enhanced VSC.


WIRING DIAGRAM


C124540E25


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (STEERING ANGLE SENSOR BRANCH WIRE)
C126177E01
  1. Disconnect the S13 steering angle sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S13-10 (CANH) - S3-9 (CANL)
    Power switch OFF
    54 to 69 Ω



NG
REPLACE STEERING ANGLE SENSOR BRANCH WIRE AND CONNECTOR (CANH, CANL)
OK


2.CHECK WIRE HARNESS (STEERING ANGLE SENSOR - BATTERY AND BODY GROUND)
C126177E02
  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    S13-2 (ESS) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    S13-1 (IG) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE STEERING ANGLE SENSOR