Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Skid Control ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
SKID CONTROL ECU COMMUNICATION STOP MODE
  1. ABS/VSC/TRAC is not displayed on "CAN Bus Check" screen Techstream
  2. Applies to "SKID CONTROL ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside skid control ECU
  2. Skid control ECU branch wire and connector

WIRING DIAGRAM


C126170E06


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (SKID CONTROL ECU BRANCH WIRE)
C126171E04
  1. Disconnect the S8 skid control ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S8-19 (CANH) - S8-18 (CANL)
    Power switch OFF
    54 to 69 Ω



NG
REPLACE SKID CONTROL ECU BRANCH WIRE AND CONNECTOR (CANH, CANL)
OK


2.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)
C126172E01
  1. Disconnect the S7, S9 and S10 skid control ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S7-1 (GND) - Body ground
    Below 1 Ω
    S8-1 (GND3) - Body ground
    Below 1 Ω
    S8-2 (GND2) - Body ground
    Below 1 Ω
    S9-1 (GND5) - Body ground
    Below 1 Ω
    S9-2 (GND4) - Body ground
    Below 1 Ω
    S10-4 (GND6) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connectors.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    S8-7 (IG1) - Body ground
    Power switch ON (IG)
    10 to 14 V
    S10-5 (IG2) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE SKID CONTROL ECU