Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Yaw Rate Sensor Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
YAW RATE SENSOR COMMUNICATION STOP MODE
  1. Yaw Rate/ Deceleration Sensor is not displayed on "CAN Bus Check" screen of Techstream
  2. Applies to "YAW RATE SENSOR COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside yaw rate sensor
  2. Yaw rate sensor branch wire and connector

NOTICE:
This detection item is not applicable to a vehicle without enhanced VSC.


WIRING DIAGRAM


C124540E26


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (YAW RATE SENSOR BRANCH WIRE)


    F100900E01
  1. Disconnect the Y1 yaw rate sensor connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Y1-2 (CANL) - Y1-3 (CANH)
    Power switch OFF
    54 to 69 Ω



NG
REPLACE YAW RATE SENSOR BRANCH WIRE AND CONNECTOR (CANH, CANL)
OK


2.CHECK WIRE HARNESS (YAW RATE SENSOR - BATTERY AND BODY GROUND)


    F100900E02
  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    Y1-1 (GND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    Y1-5 (IG)- Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE YAW RATE SENSOR