Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL-SAFE FUNCTION
  1. The fail-safe function starts if any bus (communication line) fails due to a short or other type of circuit failure. The fail-safe function differs in each system and ensures the minimum required function for each system.

  2. The table below shows the effects on each system when communication is impossible. For further details, refer to each system.

    Function
    Hybrid Vehicle Control ECU
    ECM
    Battery ECU
    Skid Control ECU
    Steering Angle Sensor
    Yaw Rate Sensor
    Power Steering ECU
    Gateway ECU
    Action when unable to communicate
    DTC detection (Driver detectable)
    TOYOTA hybrid system control (Optimum mix of the electric motor and gas engine)
    ●
    ○
    ○





    Restricted driving
    Detectable (Light comes on)
    Regenerative braking (Drives the motor as a generator using the electricity produced by the wheel's rotation. The electricity is stored in the HV battery)
    ○


    ●




    Prohibits regeneration
    Detectable (Light comes on)
    Enhanced VSC control (Controls braking force when enhanced VSC is in operation)
    ○


    ●
    ○
    ○


    Stops enhanced VSC
    Detectable (Light comes on)
    Electric power steering (Calculates assist current according to the torque sensor value and vehicle speed, then sends the data to the motor)
    ○


    ○


    ●

    Maintains control by locking amount of power assist to 70 km/h (43 mph) level of power assist.
    Detectable (Light comes on)
    Display (Operating condition, shift position, DTC)
    ○
    ○

    ○


    ○
    ●
    Meter
    Light does not come on or remains on
    Detectable by illumination malfunction
    A/C control
    ○
    ○





    ●
    A/C
    Control of A/C to level set not possible
    Detectable (Light does not come on)

    HINT:
    1. ●: Control master ECU
    2. ○: Related ECU or sensor