Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
ECM COMMUNICATION STOP MODE
  1. Engine is not displayed on "CAN Bus Check" screen of Techstream
  2. Applies to "ECM COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
Power source or inside ECM

WIRING DIAGRAM


C126178E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (ECM - BATTERY AND BODY GROUND)
C126179E01
  1. Disconnect the E4, E5, E6 and E7 ECM connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    E4-1 (E04) - Body ground
    Below 1 Ω
    E4-6 (E02) - Body ground
    Below 1 Ω
    E4-7 (E01) - Body ground
    Below 1 Ω
    E5-3 (ME01) - Body ground
    Below 1 Ω
    E5-28 (E1) - Body ground
    Below 1 Ω
    E6-7 (E03) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E7-4 (+B) - Body ground
    Power switch OFF
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM