Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Gateway ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
GATEWAY ECU COMMUNICATION STOP MODE
  1. Gateway is not displayed on CAN Bus Check" screen of Techstream
  2. Applies to "GATEWAY ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside gateway ECU
  2. Gateway ECU branch wire and connector

WIRING DIAGRAM


C126175E06


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (GATEWAY ECU BRANCH WIRE)
C126176E03
  1. Disconnect the G1 gateway ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    G1-17 (CA1H) - G1-18 (CA1L)
    Power switch OFF
    54 to 69 Ω



NG
REPLACE GATEWAY ECU BRANCH WIRE AND CONNECTOR (CA1H, CA1L)
OK


2.CHECK WIRE HARNESS (GATEWAY ECU - BATTERY AND BODY GROUND)
C126176E04
  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    G1-24 (GND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    G1-10 (BATT) - Body ground
    Always
    10 to 14 V
    G1-2 (ACC) - Body ground
    Power switch ON (ACC)
    10 to 14 V
    G1-1 (IG) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE GATEWAY ECU