Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > Power Steering ECU Communication Stop Mode

for Preparation Click here


DESCRIPTION


Detection Item
Symptom
Trouble Area
POWER STEERING ECU COMMUNICATION STOP MODE
  1. EPS is not displayed on "CAN Bus Check" screen of Techstream
  2. Applies to "POWER STEERING ECU COMMUNICATION STOP MODE" in "DTC COMBINATION TABLE"
  1. Power source or inside power steering ECU
  2. Power steering ECU branch wire and connector

WIRING DIAGRAM


C124540E24


INSPECTION PROCEDURE

1.CHECK CAN BUS LINE FOR DISCONNECTION (POWER STEERING ECU BRANCH WIRE)
C126173E01
  1. Disconnect the P8 power steering ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    P8-1 (CANH) - P8-7 (CANL)
    Power switch OFF
    54 to 69 Ω



NG
REPLACE POWER STEERING ECU BRANCH WIRE AND CONNECTOR (CANH, CANL)
OK


2.CHECK WIRE HARNESS (POWER STEERING ECU - BATTERY AND BODY GROUND)
C126174E01
  1. Disconnect the P7 power steering ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    P7-2 (PGND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    P8-6 (IG) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER STEERING ECU