BATTERY > INSTALLATION |
| 1. INSTALL BATTERY |
![]() |
Install the battery room ventilation hose to the battery.
![]() |
Install the battery to the vehicle.
Install the grommet of the battery room ventilation hose to the vehicle.
| 2. INSTALL BATTERY HOLD DOWN CLAMP |
![]() |
Install the battery hold down clamp with the bolt and nut.
| 3. INSTALL FUSIBLE LINK BLOCK ASSEMBLY |
![]() |
Install the fusible link block with the nut and clip, and then tighten the nut.
| 4. INSTALL NO. 2 QUARTER VENT DUCT |
![]() |
Install the quarter vent duct with the bolt and screw.
Install the wire harness to the quarter vent duct.
![]() |
Connect the 2 fusible link connectors.
Connect the brake control power supply connector.
| 5. INSTALL CONNECTOR COVER |
![]() |
Install the connector cover, and then attach the 3 claws.
| 6. CONNECT BATTERY NEGATIVE CABLE |
![]() |
Connect the battery negative cable, and then tighten the nut.
| 7. INSTALL REAR NO. 3 FLOOR BOARD |
![]() |
Install the floor board, and then attach the 4 claws.
| 8. INSTALL REAR DECK FLOOR BOX |
![]() |
Install the rear deck floor box to the vehicle.
| 9. INSTALL REAR NO. 2 FLOOR BOARD |
![]() |
Install the floor board, and then lock the 2 cover knobs.
| 10. PERFORM INITIALIZATION |
Perform initialization (Click here).