Home › ENGINE › 1NZ-FXE CHARGING › BATTERY

BATTERY > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT BATTERY NEGATIVE CABLE


    A088356E01
  1. Loosen the nut, and then disconnect the battery negative cable (engine wire).



5. REMOVE CONNECTOR COVER


    A088357E02
  1. Detach the 3 claws, and then remove the connector cover.



6. REMOVE NO. 2 QUARTER VENT DUCT


    A088358E01
  1. Disconnect the brake control power supply connector.

  1. Disconnect the 2 fusible link block connectors.

  1. Remove the wire harness from the quarter vent duct.



    A088359E01
  1. Remove the bolt and screw, and then remove the quarter vent duct.



7. REMOVE FUSIBLE LINK BLOCK ASSEMBLY


    A088360E01
  1. Using a clip remover, remove the clip.

  1. Loosen the nut, and then remove the fusible link block.



8. REMOVE BATTERY HOLD DOWN CLAMP


    A088361E01
  1. Remove the bolt and nut, and then remove the battery hold down clamp.



9. REMOVE BATTERY


    A088362E01
  1. Remove the grommet of the battery room ventilation hose from the vehicle.

  1. Remove the battery from the vehicle.



    A088363E01
  1. Remove the battery room ventilation hose from the battery.