Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › HYBRID BATTERY SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0293    Lost Communication with HV ECU

for Preparation Click here


DESCRIPTION

The battery ECU receives signals from the hybrid vehicle control ECU, ECM, and gateway ECU via CAN (Controller Area Network) communication.

DTC No.
DTC Detection Condition
Trouble Area
U0100
CAN communication malfunction (no signal reception) with ECM
CAN communication system
U0293
CAN communication malfunction (no signal reception) with hybrid vehicle control ECU
CAN communication system

MONITOR DESCRIPTION

If the battery ECU detects malfunction in the CAN communication with the ECM or hybrid vehicle control ECU, it illuminates the MIL and sets a DTC.

MONITOR STRATEGY


U0100: 
Related DTCs
U0100: Communication between ECM and battery ECU/Non-received check
Required sensors/components
Main: ECM
Sub: CAN bus line
Frequency of operation
Continuous
Duration
0.68 seconds or more
MIL operation
Immediate or 1 driving cycle
Sequence of operation
None

U0293: 
Related DTCs
U0293: Communication between hybrid vehicle control and battery ECU/Non-received check
Required sensors/components
Main: Hybrid vehicle control ECU
Sub: CAN bus line
Frequency of operation
Continuous
Duration
0.68 seconds or more
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Receiving data
No reception

COMPONENT OPERATING RANGE


ECM
DTC U0100 is not detected
Hybrid vehicle control ECU
DTC U0293 is not detected

INSPECTION PROCEDURE

1.READ DTC OUTPUT (CODES ALL)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG) and the tester ON.

  1. Enter the following menus: Bus Check / Communication Malfunction DTC.

  1. Read and record DTCs.

    HINT:
    When DTCs other than CAN communication malfunction DTCs are output simultaneously, first correct the CAN communication problem, and then perform troubleshooting for other DTCs.


NEXT

GO TO CAN COMMUNICATION SYSTEM