Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › HYBRID BATTERY SYSTEM

DTC    P0A7F    Hybrid Battery Pack Deterioration

for Preparation Click here


DESCRIPTION

C115845E01
The battery ECU calculates the SOC (state of charge) of the HV battery by estimating the amperage that flows into the HV battery and monitoring other values.
The battery ECU sends the calculated SOC to the hybrid vehicle control ECU. The hybrid vehicle control ECU charges and discharges the HV battery depending on driving patterns based on the information sent by the battery ECU.

DTC No.
DTC Detection Condition
Trouble Area
P0A7F
When either condition below is met:
  1. Resistance of HV battery assembly is higher than standard (1 trip detection logic)
  2. When the capacity difference between battery modules exceeds the specified value (2 trip detection logic)
  1. HV battery assembly
  2. Battery ECU

MONITOR DESCRIPTION

The battery ECU calculates the resistance of the HV battery through amperage and voltage, and uses this resistance to determine the extent of deterioration of the HV battery. If the battery ECU detects that the resistance of the HV battery has exceeded the standard, it determines that malfunction has occurred. In addition, the battery ECU monitors the SOC, and if the difference between the maximum and minimum SOC values exceeds the standard, it determines that malfunction has occurred. When either of the malfunction detection conditions is met, the battery ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A7F: HV battery/Rationality
Required sensors/components
Main: Battery voltage sensor inside battery ECU, battery current sensor
Sub: Battery temperature sensor
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
Immediate or 2 driving cycles
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Either of the following condition
(1) or (2)
(1) Internal resistance
Exceeds the standard level
(2) The difference between the maximum SOC and the minimum SOC
Exceeds the standard level

COMPONENT OPERATING RANGE


TOYOTA's intellectual property
-

INSPECTION PROCEDURE

1.READ DTC OUTPUT (DTC P0A1F IS OUTPUT)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG) and the tester ON.

  1. Enter the following menus: Powertrain / HV Battery / DTC.

  1. Read DTCs.

    Result:
    DTC P0A1F is output



YES
REPLACE BATTERY ECU
NO

REPLACE HV SUPPLY BATTERY ASSEMBLY