Home › HYBRID SYSTEM › P112 HYBRID BATTERY CONTROL › HYBRID BATTERY SYSTEM

DTC    P0A80    Replace Hybrid Battery Pack

for Preparation Click here


DESCRIPTION

The HV battery assembly consists of nickel hydride batteries. Nickel hydride batteries do not require external charging. The SOC (state of charge) of the HV battery is maintained at a constant voltage level by the hybrid vehicle control ECU while the vehicle is being driven. In the HV battery assembly, 28 modules are connected in series, and each module has six 1.2 V cells that are connected in series. Thus, the HV battery assembly contains a total of 168 cells which produce 201.6 V.
The battery ECU, which monitors two modules as a single battery block, detects the battery block voltage at a total of 14 locations.
C115846E01

DTC No.
DTC Detection Condition
Trouble Area
P0A80
Voltage difference between battery blocks is higher than standard (2 trip detection logic)
  1. HV battery assembly
  2. Battery ECU

MONITOR DESCRIPTION

The battery ECU, which monitors the voltage of the battery blocks, determines that malfunction has occurred if a voltage difference between the battery blocks exceeds the standard. When the malfunction detection condition is satisfied, the battery ECU illuminates the MIL and sets a DTC.

MONITOR STRATEGY


Related DTCs
P0A80: HV battery/Rationality
Required sensors/components
Main: Battery voltage sensor inside battery ECU
Sub: Battery current sensor, battery temperature sensor
Frequency of operation
Continuous
Duration
TOYOTA's intellectual property
MIL operation
2 driving cycles
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the following DTCs are not present
TOYOTA's intellectual property
Other conditions belong to TOYOTA's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


Battery voltage difference
Exceeds the standard level

COMPONENT OPERATING RANGE


TOYOTA's intellectual property
-

INSPECTION PROCEDURE

1.READ DTC OUTPUT (DTC P0A1F IS OUTPUT)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG) and the tester ON.

  1. Enter the following menus: Powertrain / HV Battery / DTC.

  1. Read DTCs.

    Result:
    DTC P0A1F is output



YES
REPLACE BATTERY ECU
NO

REPLACE HV SUPPLY BATTERY ASSEMBLY