Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System)

WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Key System) > No Answer-back

for Preparation Click here


DESCRIPTION

In some cases, wireless door lock control functions are normal but the hazard warning lights and / or wireless door lock buzzer answer-back function(s) is not. In such cases, the main body ECU's hazard warning lights and wireless door lock buzzer signal outputs may be malfunctioning.

NOTICE:
Troubleshooting should be started after confirming that the answer-back function has been switched ON.


WIRING DIAGRAM


B150419E01


INSPECTION PROCEDURE

1.CHECK WIRELESS DOOR LOCK CONTROL FUNCTION
  1. Check the wireless door lock control function by operating the transmitter switch.

    Result: 
    Result
    Proceed to
    Wireless door lock functions are normal but hazard warning lights answer-back does not occur
    A
    Wireless door lock functions are normal but wireless door lock buzzer answer-back does not occur
    B
    Doors cannot be locked and unlocked with transmitter
    C



B
Go to step 4

C
GO TO PROBLEM SYMPTOMS TABLE
A


2.PERFORM ACTIVE TEST BY TECHSTREAM (TURN SIGNAL FLASHER RELAY)
  1. Select the ACTIVE TEST, use the Techstream to generate a control command, and then check that the hazard warning lights flash.

    Main body ECU: 
    Item
    Test Details
    Diagnostic Note
    Hazard
    Turn signal flasher relay ON / OFF
    -

    OK:
    Turn signal flasher relay turns ON / OFF.



OK
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)
NG


3.CHECK HAZARD WARNING LIGHT
  1. Check that the hazard warning lights flash continuously when the hazard warning signal switch is pressed.

    OK:
    Hazard warning lights flash continuously.



NG
GO TO LIGHTING SYSTEM
OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU) 

4.INSPECT WIRELESS DOOR LOCK BUZZER
B127185
  1. Measure the resistance between terminals 1 and 2 of the buzzer.

    Standard resistance:
    Approximately 1 kΩ

    NOTICE:
    1. The buzzer circuit is built into the main body ECU, not into the buzzer itself.
    2. When battery voltage is directly applied to the buzzer, the buzzer does not sound.



NG
REPLACE WIRELESS DOOR LOCK BUZZER
OK


5.CHECK WIRE HARNESS (WIRELESS DOOR LOCK BUZZER - MAIN BODY ECU AND BODY GROUND)
B127186E02
  1. Disconnect the W6 buzzer connector.

  1. Disconnect the B6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    W6-1 - B6-13 (BUZ)
    Below 1 Ω
    W6-2 - Body ground
    W6-1 - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY (MAIN BODY ECU)