AIR CONDITIONING UNIT > DISASSEMBLY |
| 1. REMOVE BLOWER ASSEMBLY |
![]() |
Remove the 2 screws.
Disengage the fittings with the air conditioner and then remove the blower.
| 2. REMOVE DEFROSTER NOZZLE ASSEMBLY LOWER |
![]() |
Detach the 2 claws and remove the defroster nozzle lower.
| 3. REMOVE AIR MIX CONTROL SERVO MOTOR |
![]() |
Remove the 2 screws and air mix control servo motor.
| 4. REMOVE AIR OUTLET CONTROL SERVO MOTOR |
![]() |
Remove the 2 screws and disengage the claw.
Detach the claw and remove the air outlet control servo motor.
| 5. REMOVE AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY |
![]() |
Remove the 2 screws and expansion valve cover.
![]() |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.
Remove the air conditioning tube.
Remove the 2 O-rings from the air conditioning tube assembly.
| 6. REMOVE COOLER EXPANSION VALVE |
![]() |
Remove the cooler expansion valve from the No. 1 cooler evaporator.
| 7. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Detach the clamp and disconnect the evaporator temperature sensor connector.
Detach the clamp and 2 claws, and remove the heater piping cover.
![]() |
Remove the 4 screws and 4 clamps.
Remove the radiator heater unit from the air conditioner radiator.
| 8. REMOVE NO. 1 AIR DUCT |
![]() |
Remove the 2 screws and No. 1 air duct.
| 9. REMOVE QUICK HEATER ASSEMBLY |
![]() |
Remove the 4 screws and quick heater.
| 10. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY |
![]() |
Remove the 7 screws and No. 1 cooler evaporator from the heater case.
![]() |
Remove the 2 O-rings from the No. 1 cooler evaporator.
| 11. REMOVE EVAPORATOR TEMPERATURE SENSOR |
![]() |
Detach the 2 claws and remove the evaporator temperature sensor.