Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › BLOWER UNIT

BLOWER UNIT > DISASSEMBLY

for Preparation Click here



1. REMOVE AIR INLET SERVO MOTOR


    I038843E01
  1. Remove the 3 screws and air inlet servo motor.



2. REMOVE BLOWER MOTOR CONTROL


    I038844E01
  1. Disconnect the connector.

  1. Remove the 2 screws and blower motor control.



3. REMOVE NO. 2 COOLER WIRING HARNESS SUB-ASSEMBLY


    I038845E01
  1. Remove the 5 screws and blower motor cover.



    I038847E01
  1. Remove the No. 2 cooler wiring harness from the blower with fan motor.



4. REMOVE BLOWER WITH FAN MOTOR SUB-ASSEMBLY


    I038846E01
  1. Remove the 3 screws and blower with fan motor.



5. REMOVE CLEAN AIR FILTER


    I038848E02
  1. Detach the 2 claws and then remove the air filter cover plate with the clean air filter.

  1. Remove the clean air filter from the air filter cover plate.