Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › CONDENSER

CONDENSER > REASSEMBLY

for Preparation Click here



1. INSTALL COOLER DRYER


    I032994E01
  1. Using pliers, install the cooler dryer to the modulator.

  1. Install a new O-ring to the cap.



    E055408E02
  1. Sufficiently apply compressor oil (ND-OIL 11) to the O-ring and cap fitting surface.

    Compressor oil:
    ND-OIL 11 or equivalent

    NOTICE:
    1. Do not use any compressor oil other than ND-OIL 11.
    2. If any compressor oil other than ND-OIL 11 is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.



    I032993E05
  1. Using a 14 mm hexagon wrench, install the cap to the modulator.

    Torque:
    2.9 N*m{ 30 kgf*cm , 25 in.*lbf }