ELECTRONICALLY CONTROLLED BRAKE SYSTEM > PRECAUTION |
| 1.TROUBLESHOOTING PRECAUTION |
When there is a malfunction with terminal contact points or part installation problems, removal and installation of the suspected problem parts may return the system to the normal condition either completely or temporarily.
In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as DTC output and the Freeze Frame Data, and record it before disconnecting each connector or removing and installing parts.
Since the system may be influenced by malfunctions in systems other than the brake control system, be sure to check for DTCs in other systems.
| 2.HANDLING PRECAUTION |
Do not remove or install the Enhanced VSC or Electronically Controlled Brake parts such as the steering sensor, yaw rate sensor or brake pedal stroke sensor except when required, as they need to be adjusted correctly after removal or installation.
Be sure to perform preparation before work and confirmation after work is completed by following the directions in the repair manual when working on the Enhanced VSC or Electronically Controlled Brake system.
Be sure to remove and install the ECU, actuator, each sensor, etc. with the power switch OFF unless otherwise specified in the inspection procedure.
Be sure to remove the 2 main relays before removal and installation, or replacement of the Enhanced VSC or Electronically Controlled Brake parts.
The removal or installation of the actuator, master cylinder or stroke simulator as well as some other procedures can cause the fluid level to drop below the fluid reservoir port. If this happens when performing such work, be sure to remove the 2 motor relays until the bleeding of the air in the pipeline is completed.
Removal of the main relay and motor relay
Wait for 2 minutes after turning the power switch OFF, stopping the brake pedal operation and closing the driver door before removing the 2 relays.
When removing and installing the ECU, actuator and each sensor, be sure to check that the normal display is output in Test Mode inspection and in DTC output inspection after installing all the parts.
| 3.DTC PRECAUTION |
Warnings for some DTCs cannot be cleared only by repairing the malfunctioning parts. If the warning is displayed after repair work, the DTC should be cleared after turning the power switch OFF.
| 4.FAIL-SAFE PRECAUTION |
When trouble occurs in the brake control systems, the skid control ECU lights up the warning lights (Electronically Controlled Brake, ABS, Enhanced VSC and BRAKE) corresponding to the malfunctioning systems and prohibits ABS, Enhanced VSC and brake assist operation.
The control of the Electronically Controlled Brake can be continued by only the normal parts according to the malfunction.
| 5.CHASSIS DYNAMOMETER PRECAUTION |
When using the chassis dynamometer, be sure to follow the procedures below to prohibit the Enhanced VSC operation.
| 6.CAN COMMUNICATION SYSTEM PRECAUTION |
The CAN communication system is used for the data communication between the skid control ECU, the steering sensor, the yaw rate sensor (deceleration sensor included) and other ECUs. If there is trouble with the CAN communication line, corresponding DTCs in the communication line are output.
If a CAN communication line DTC is output, repair the malfunction in the communication line and troubleshoot the Enhanced VSC system while data communication is normal.
Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a bypass wire, etc.
| 7.NOTICES FOR INITIALIZATION |
| System Name | See Procedure |
| Power Window Control System |
Click here
|
| 8.NOTICES |
FOR HYBRID SYSTEM ACTIVATION