ELECTRONICALLY CONTROLLED BRAKE SYSTEM > CALIBRATION |
| DESCRIPTION |
Zero point calibration is not performed until the data is cleared when the zero point is once stored. Zero point calibration should be performed after the zero point is cleared if the yaw rate (deceleration) sensor is replaced.
Steering sensor zero point calibration is automatically performed with the vehicle driving straight.
Follow the chart to perform calibration.
| Replacing Parts | Necessary Operation |
| Skid Control ECU | Yaw rate (deceleration) sensor zero point calibration. |
| Yaw Rate (Deceleration) Sensor | 1. Clearing zero point calibration data. 2. Yaw rate sensor and deceleration sensor zero point calibration. |
| CLEAR ZERO POINT CALIBRATION |
Clearing the DTCs.
Connect Techstream to the DLC3.
Turn the power switch ON (READY).
Operate Techstream to erase the codes.
| PERFORM ZERO POINT CALIBRATION OF YAW RATE SENSOR AND DECELERATION SENSOR |
Check that the steering wheel is in the centered position and move the shift lever to the P position.
Connect Techstream to the DLC3.
Turn the power switch ON (READY).
Operate Techstream to Test Mode.
Obtain the zero point of the yaw rate sensor and deceleration sensor.
Keep the vehicle in the stationary condition on a level surface for 2 seconds or more.
Check that the VSC warning light blinks.
Turn the power switch OFF.