Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > CHECK FOR INTERMITTENT PROBLEMS

for Preparation Click here



CHECK FOR INTERMITTENT PROBLEMS

HINT:
A momentary interruption (open circuit) in the connectors and / or wire harness between the sensors and ECUs can be detected in the ECU data monitor function of Techstream.

  1. Turn the power switch OFF and connect Techstream to the DLC3.



  2. C106657E32
  3. Turn the power switch ON (READY). Follow the on-screen directions on Techstream to display the Data List and select areas where momentary interruption should be monitored.

    HINT:
    A momentary interruption (open circuit) cannot be detected for 3 seconds after the power switch is turned ON (READY) (initial check).


    ABS / VSC / TRAC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Speed Open
    FR speed sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    FL Speed Open
    FL speed sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    RR Speed Open
    RR speed sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    RL Speed Open
    RL speed sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    Yaw Rate Open
    Yaw rate sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    Deceleration Open
    G sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    Steering Open
    Steering sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    Master Cylinder 1 Open
    Master cylinder pressure sensor 1 open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    Master Cylinder 2 Open
    Master cylinder pressure sensor 2 open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    Pedal Stroke 1 Open
    Pedal stroke 1 open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    FR Wheel Cylinder Open
    FR wheel cylinder open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    FL Wheel Cylinder Open
    FL wheel cylinder open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    RR Wheel Cylinder Open
    RR wheel cylinder open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    RL Wheel Cylinder Open
    RL wheel cylinder open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    HV Open
    HV communication open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -
    Accumulator Open
    Accumulator pressure sensor open detection / OPN-DET or NORMAL
    NORMAL: Normal condition
    -

    HINT:
    1. If the status remains on, check the continuity between the ECU and the sensors, or between ECUs.
    2. The OPN-DET display on Techstream remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.



  4. F047126E05
  5. While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

    Result:
    Display does not change.

    HINT:
    The connector and / or wire harness will have momentary interruptions (open circuit) if the chart fluctuates. Repair or replace connector and / or wire harness as one of them is faulty.