Home › BRAKE › BRAKE CONTROL › ELECTRONICALLY CONTROLLED BRAKE SYSTEM

ELECTRONICALLY CONTROLLED BRAKE SYSTEM > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA

HINT:
  1. Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as Freeze Frame Data.
  2. The skid control ECU stores the number of times (maximum: 31) the power switch has been turned from OFF to the ON (IG or READY) position since the last time ABS was activated. However, if the vehicle was stopped or at low speed (4.3 mph (7 km/h) or less), or if a DTC is detected, the skid control ECU will not count the number since then.
  3. Freeze Frame Data at the time the ABS operates: The skid control ECU stores and updates data whenever the ABS system operates. When the ECU stores data at the time a DTC is detected, the data stored when the ABS operated is erased.
  4. Freeze Frame Data at the time a DTC is detected: When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

  1. Connect Techstream to the DLC3.

  2. Turn the power switch ON (READY).

  3. From the display on the tester, select the Freeze Frame Data.

    ABS / VSC / TRAC: 
    Tester Display
    Measurement Item
    Reference Value
    Freeze DTC
    Freeze frame DTC
    0 to 255
    Detailed Freeze DTC
    Detailed code for freeze DTC
    0 to 65535
    Stop Light SW
    Stop light switch
    Stop light switch ON: ON, OFF: OFF
    Shift Lever Position
    Shift position
    Fail
    P, N
    R
    D (M)
    4
    3
    2
    L
    Operated System
    System
    ABS
    VSC (TRC)
    BA
    HAB
    FAIL SAFE
    NO SYS
    Number of IG ON
    Number of operations of power switch on (IG) after storing Freeze Frame Data
    0 to 31
    Vehicle Speed
    Vehicle speed
    Min.: 0 km/h (0 mph)
    Max.: 326 km/h (202 mph)
    Steering Angle Sensor
    Steering sensor
    1. Left turn: Increase
    2. Right turn: Drop (Deceleration)
    Yaw Rate Sensor
    Yaw rate sensor
    -128 to 127 deg/s
    Master Cylinder Sensor 1
    Master cylinder pressure
    0 to 5 V
    Pedal Stroke Sensor 1
    Stroke sensor
    0 to 5.1 V
    Throttle Sensor
    Throttle position sensor
    Release accelerator pedal:
    Approx. 0 deg.
    Depress accelerator pedal:
    Approx. 125 deg.
    Master Cylinder Grade
    Master pressure sensor grade
    30 to 225 Mpa/s
    Right And Left G
    Right and left G
    -1869 to 1869 G
    Back And Forth G
    Back and forth G
    -1869 to 1869 G
    Vehicle Speed Grade
    Vehicle speed grade
    -1869 to 1869 G
    Buzzer
    Buzzer
    Buzzer ON: ON, OFF: OFF
    Reservoir Warning SW
    Reservoir level warning switch
    Reservoir level warning switch ON: ON, OFF: OFF
    Parking Brake SW
    Parking brake switch
    Parking brake switch ON: ON, OFF: OFF
    FR Wheel Cylinder
    FR wheel cylinder pressure sensor
    0 to 5 V
    FL Wheel Cylinder
    FL wheel cylinder pressure sensor
    0 to 5 V
    RR Wheel Cylinder
    RR wheel cylinder pressure sensor
    0 to 5 V
    RL Wheel Cylinder
    RL wheel cylinder pressure sensor
    0 to 5 V
    Accumulator Sensor
    Accumulator pressure sensor
    0 to 5 V
    Master Cylinder Sensor 2
    Master cylinder pressure sensor 2
    0 to 5 V
    Pedal Stroke Sensor 2
    Stroke sensor 2
    0 to 5 V
    MTT
    MTT
    0 to 5 V
    IG1 Voltage
    Voltage value of IG1
    0 to 20 V
    IG2 Voltage
    Voltage value of IG2
    0 to 20 V
    BS1
    BS1
    0 to 20 V
    BS2
    BS2
    0 to 20 V
    VM1
    VM1
    0 to 20 V
    VM2
    VM2
    0 to 20 V
    +B1
    +B1
    0 to 5 V
    +B2
    +B2
    0 to 5 V
    FR Target Oil Pressure
    Target oil pressure (FR)
    0 to 20 V
    FL Target Oil Pressure
    Target oil pressure (FL)
    0 to 20 V
    RR Target Oil Pressure
    Target oil pressure (RR)
    0 to 20 V
    RL Target Oil Pressure
    Target oil pressure (RL)
    0 to 20 V
    SLAFR Solenoid Current
    Current of SLAFR solenoid
    0 to 1.5 A
    SLAFL Solenoid Current
    Current of SLAFL solenoid
    0 to 1.5 A
    SLARR Solenoid Current
    Current of SLARR solenoid
    0 to 1.5 A
    SLARL Solenoid Current
    Current of SLARL solenoid
    0 to 1.5 A
    SLRFR Solenoid Current
    Current of SLRFR solenoid
    0 to 1.5 A
    SLRFL Solenoid Current
    Current of SLRFL solenoid
    0 to 1.5 A
    SLRRR Solenoid Current
    Current of SLRRR solenoid
    0 to 1.5 A
    SLRRL Solenoid Current
    Current of SLRRL solenoid
    0 to 1.5 A
    FR Wheel Speed
    Front right wheel speed
    Min.: 0 km/h (0mph)
    Max.: 255 km/h (158 mph)
    FL Wheel Speed
    Front left wheel speed
    Min.: 0 km/h (0mph)
    Max.: 255 km/h (158 mph)
    RR Wheel Speed
    Rear right wheel speed
    Min.: 0 km/h (0mph)
    Max.: 255 km/h (158 mph)
    RL Wheel Speed
    Rear left wheel speed
    Min.: 0 km/h (0mph)
    Max.: 255 km/h (158 mph)
    Capacitor Mode
    Capacitor mode
    ON: ON, OFF: OFF
    ECB* Solenoid (SCSS)
    SCSS
    ON: ON, OFF: OFF
    ECB* Solenoid (SMC1)
    SMC1
    ON: ON, OFF: OFF
    ECB* Solenoid (SMC2)
    SMC2
    ON: ON, OFF: OFF
    Motor Relay 1
    Motor relay 1
    ON: ON, OFF: OFF
    Motor Relay 2
    Motor relay 2
    ON: ON, OFF: OFF
    ECB* Main Relay 1
    Main relay 1
    ON: ON, OFF: OFF
    ECB* Main Relay 2
    Main relay 2
    ON: ON, OFF: OFF
    *: Electronically Controlled Brake