Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

DTC    B1244    Light Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a failure in the light sensor circuit is detected.

DTC No.
DTC Detection Condition
Trouble Area
B1244
When either condition below is met:
  1. Malfunction in automatic light control sensor
  2. Open or short in automatic light control sensor circuit
  1. Automatic light control sensor
  2. Wire harness
  3. Main body ECU

WIRING DIAGRAM


E118453E15


INSPECTION PROCEDURE

1.CHECK BODY ECU
I039976E01
  1. Disconnect the A24 sensor connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1 (CLTB) - 3 (CLTE)
    Power switch ON (IG)
    10 to 14 V



N G
Go to step 4
OK


2.CHECK WIRE HARNESS (SENSOR - ECU)
I102531E01
  1. Disconnect the A24 sensor connector.

  1. Disconnect the B6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A24-4 (CLTS) - B6-15 (CLTS)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.REPLACE AUTOMATIC LIGHT CONTROL SENSOR

OK:
Returns to normal operation.



NG
REPLACE DRIVER SIDE JUNCTION BLOCK (MAIN BODY ECU)
OK

END 

4.CHECK WIRE HARNESS (SENSOR - BODY GROUND)
I039976E03
  1. Disconnect the A24 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A24-1 (CLTB) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
Go to step 6
OK


5.CHECK WIRE HARNESS (SENSOR - ECU)
I102531E02
  1. Disconnect the A24 sensor connector.

  1. Disconnect the B6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A24-3 (CLTE) - B6-14 (CLTE)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK (MAIN BODY ECU) 

6.CHECK WIRE HARNESS (SENSOR - ECU)
I102531E03
  1. Disconnect the A24 sensor connector.

  1. Disconnect the B6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A24-1 (CLTB) - B6-16 (CLTB)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE DRIVER SIDE JUNCTION BLOCK (MAIN BODY ECU)