Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The main body ECU detects the condition of the door courtesy switch.

WIRING DIAGRAM


I102412E02


INSPECTION PROCEDURE

HINT:
The procedure for each door courtesy switch circuit is the same. First, inspect the suspected door courtesy switch circuit.

1.READ VALUE OF TECHSTREAM (DOOR COURTESY LIGHT SWITCH)
  1. Check the DATA LIST for proper functioning of the transistor relay.

    Main body ECU 
    Item
    Measurement Item / Display (Range)
    Normal Condition
    Diagnostic Note
    D Door Courtesy SW
    Driver door courtesy switch signal / ON or OFF
    ON: Driver's door is open
    OFF: Driver's door is closed
    -
    P Door Courtesy SW
    Passenger door courtesy switch signal / ON or OFF
    ON: Passenger's door is open
    OFF: Passenger's door is closed
    -
    Rear Door Courtesy SW
    Rear door courtesy switch signal / ON or OFF
    ON: Either right or left door is open
    OFF: Both the right and left doors are closed
    -



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK DRIVER SIDE JUNCTION BLOCK (BODY ECU)
I102537E02
  1. Disconnect the 1D junction block connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1D-21 (DCTY) - Body ground
    Driver door is open
    Below 1 Ω
    Driver door is closed
    10 kΩ or higher
    1D-24 (PCTY) - Body ground
    Front passenger door is open
    Below 1 Ω
    Front passenger door is closed
    10 kΩ or higher
    1D-20 (RCTY) - Body ground
    Rear RH door is open
    Below 1 Ω
    Rear RH door is closed
    10 kΩ or higher
    1D-5 (RCTY) - Body ground
    Rear LH door is open
    Below 1 Ω
    Rear LH door is closed
    10 kΩ or higher



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


3.INSPECT DOOR COURTESY LIGHT SWITCH
E071371E06
  1. Remove the courtesy light switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    OFF
    10 kΩ or higher
    ON
    Below 1 Ω



NG
REPLACE DOOR COURTESY LIGHT SWITCH
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (EACH COURTESY SWITCH CIRCUIT)