Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Height Control Sensor Circuit

for Preparation Click here


DESCRIPTION

The headlight beam level control ECU receives the height control sensor signal from the height control sensor or height control ECU.
The headlight beam level control ECU calculates a height value from the height control signal. The voltage at the power source of the height control sensor is corrected when SHR is detected.

WIRING DIAGRAM


E118453E12


INSPECTION PROCEDURE

1.INSPECT REAR HEIGHT CONTROL SENSOR
I039980E04
  1. Connect 3 dry cell batteries (1.5 V) in series.

  1. Connect the positive (+) lead from the battery to terminal 3 (SHB) and negative (-) lead from the battery to terminal 1 (SHG).

  1. Measure the voltage between terminals 1 (SHG) and 2 (SHRL) when slowly moving the link up and down.

    Standard voltage:
    Link Angle
    Specified Condition
    +45° (High)
    Approx. 4.5 V
    0° (Normal)
    Approx. 2.5 V
    -45° (Low)
    Approx. 0.5 V



NG
REPLACE REAR HEIGHT CONTROL SENSOR
OK


2.CHECK WIRE HARNESS (SENSOR - ECU)
I039981E03
  1. Disconnect the H18 sensor connector.

  1. Disconnect the H12 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    H12-20 (SGR) - H18-1 (SHG)
    Below 1 Ω
    H12-5 (SHR) - H18-2 (SHRL)
    H12-2 (SBR) - H18-3 (SHB)
    H18-1 (SHG) - Body ground
    10 kΩ or higher
    H18-2 (SHRL) - Body ground
    H18-3 (SHB) - Body ground



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE