Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Leveling ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to operate the headlight beam level control ECU.

WIRING DIAGRAM


I102409E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (ECU - BATTERY)
I039979E04
  1. Disconnect the H12 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    H12-1 (IG) - H12-24 (E1)
    Power switch ON (IG)
    10 to 14 V
    Power switch OFF
    Below 1 V



OK
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK WIRE HARNESS (ECU - BODY GROUND)
I039979E05
  1. Disconnect the H12 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    H12-24 (E1) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR (GROUND CIRCUIT)
OK

REPAIR OR REPLACE HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)