LIGHTING SYSTEM > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | HIGH-level CAN bus line | Power switch is OFF* | 54 to 67 Ω |
| CANH (6) - Battery positive | HIGH-level CAN bus line | Power switch is OFF* | 1 MΩ or higher |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Power switch is OFF* | 3 MΩ or higher |
| CANL (14) - Battery positive | LOW-level CAN bus line | Power switch is OFF* | 1 MΩ or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Power switch is OFF* | 3 MΩ or higher |