Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > INITIALIZATION

for Preparation Click here



HEADLIGHT BEAM LEVEL CONTROL ECU INITIALIZATION

NOTICE:
  1. Initialize the headlight beam level control ECU when: vehicle height changes by such means as removal, installation, and replacement of the height control sensor, replacement of the suspension, or replacement of the headlight beam level control ECU assembly.
  2. Adjust the headlight aim after initializing the headlight beam level control ECU (Click here).



1.CHECK VEHICLE CONDITION
  1. Leave approximately 10 liters of fuel in the tank (fuel indicator shows approximately 2 segments).

  2. Unload the vehicle.

  3. Check that there is no passenger in the vehicle.

  4. Turn off the headlights.


NEXT


2.CHECK WARNING INDICATOR
  1. Turn the power switch ON (IG) and check if the warning indication appears.

    Standard:
    Master warning in the meter blinks and "AUTO LEVELING WARNING" appears.

    HINT:
    Warning indication appears only when replacing with a new headlight beam level control ECU. Go to "OK" for removal / installation of the headlight beam level control ECU, replacement / removal / installation of the height control sensor, or replacement of the suspension.



NG.
CHECK HEADLIGHT BEAM LEVEL CONTROL ECU, WIRE HARNESS AND CONNECTOR
OK


3.INITIALIZATION


    H100769E68
  1. Connect terminals 4 (CG) and 8 (OP3) of the DLC3 using the SST.

  2. Flash the headlight more than 3 times within 20 seconds using the headlight dimmer switch. Check if the warning indication appears (step A).

  3. NOTICE:
    Flash the headlight at an interval of 1 second


    OK 
    Action
    Warning indication
    headlight beam level control ECU replacement (new)
    Appears → Disappears (initialization complete)
    headlight beam level control ECU removal / installation, height control sensor replacement / removal / installation, or suspension replacement
    Does not appear → Appears (initialization complete) → Disappears


NG.
RETURN TO "CHECK WARNING INDICATOR" IF INITIALIZATION DOES NOT SUCCEED AFTER REPEATING STEP A MORE THAN 20 TIMES
OK

INITIALIZATION COMPLETE