Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > FAIL-SAFE CHART

for Preparation Click here



HEADLIGHT BEAM LEVEL CONTROL ECU
  1. If the headlight beam level control ECU detects the following malfunctions, it performs the fail safe control, blinks the master warning light in the combination meter, and displays "AUTO LEVELING WARNING" on the multi-display.

    Item
    Condition to Transfer
    Condition to Return
    Warning Indication
    Over voltage*1
    Detects input voltage of more than 18.5 V
    Detects less than 17.5 V
    Appears
    Low voltage*1
    Detects input voltage of less than 9 V
    Detects more than 9.3 V
    Does not appear
    Vehicle height sensor malfunction*1
    When either condition below is met:
    1. Detects vehicle height sensor supply voltage of less than 4 V
    2. Detects vehicle height signal malfunction (not within 0.5 V and 4.5 V)
    3. Vehicle height sensor power source supply line is open, or short to GND
    4. Vehicle height sensor GND line is open
    Detects normal voltage for 5 sec.
    Appears
    Microcomputer*1
    Detects ECU malfunction
    Cancels reset of microcomputer
    Appears
    Leveling angle calculation value*2
    Calculates values out of the actuator's operative range
    -
    Does not appear

    HINT:
    *1: Stops the actuator operation.
    *2: Replaces the minimum or maximum value of the actuator's operating range with the calculated value.


BODY ECU (CONLIGHT CONTROL)
  1. The body ECU keeps the headlight or taillight on if there is a malfunction in the light sensor systems while the headlight is on due to the conlight control (headlight dimmer switch is in AUTO position).

  2. The body ECU prohibits conlight control if there is a malfunction in the sensor systems when the headlight turns off.