SMART KEY SYSTEM > SYSTEM DESCRIPTION |
| SMART KEY SYSTEM DESCRIPTION |
| FUNCTION OF MAIN COMPONENTS |
| Components | Function |
| Key | Receives signals from oscillators and returns ID code to door control receiver |
| Door Electrical Key Oscillator (driver and front passenger doors) | Intermittently transmits key detection signals within detection area around each door upon receiving transmission request signal from certification ECU |
| Indoor Electrical Key Oscillator | Transmits key detection signals within detection area in vehicle interior upon receiving transmission request signal from certification ECU |
| Luggage Compartment Electrical Key Oscillator (inner) | Transmits key detection signals within detection area in luggage room upon receiving transmission request signal from certification ECU |
| Luggage Compartment Electrical Key Oscillator (outer) | Transmits key detection signals within detection area around luggage compartment door upon receiving transmission request signal from certification ECU |
| Electrical Key Antenna (luggage) | Transmits luggage electrical key oscillator signal |
| Outside Door Handle (driver and front passenger doors) (touch sensor) | Transmits door unlock request signal to certification ECU when inside of outside door handle is touched |
| Outside Door Handle (driver and front passenger doors) (antenna) | Transmits door electrical key oscillator signal |
| Outside Door Handle (driver and front passenger doors) (lock switch) | Transmits door unlock request signal to certification ECU |
| Back Door Opening Switch | Transmits back door open request signal to certification ECU via main body ECU |
| Door Control Receiver | Receives ID code from key and transmits it to certification ECU |
| Power Switch | Changes vehicle's power modes between 4 stages (OFF, ON (ACC), ON (IG), and ON (READY)) in accordance with shift position, state of stop light switch and check results of key |
| Key Cancel Switch | Turns smart key system ON / OFF |
| Stop Light Switch | Outputs state of brake pedal to power source control ECU |
| Combination Meter (key warning light) | Certification ECU illuminates key warning light when these conditions occur: Key is moved out of vehicle while engine is in operation or key is left in vehicle, and door lock is operated |
| Combination Meter (buzzer) | Certification ECU sounds buzzer when these conditions occur: Key is moved out of vehicle while engine is in operation or key is left in vehicle, and door lock is operated |
| Wireless Door Lock Buzzer | Certification ECU sounds wireless door lock buzzer when these conditions from occurring: Key is moved out of vehicle while engine is in operation or key is left in vehicle, and door lock is operated |
| Certification ECU | Identifies and check ID codes from door control receiver, then transmits signals to ECU's if ID codes match. Upon receiving signals from switches, certification ECU transmits intermittent transmission request signals to door electrical key oscillators and transmission request signals to other oscillators in accordance with conditions. |
| Power Source Control ECU | Main control of smart key system (for starting). Receives results of ID code check of key provided by certification ECU via transponder key ECU. When check results show that ID code is legitimate, power source control ECU authorizes transition of power modes through operation of power switch. |
| Transponder Key ECU | Main control of engine immobiliser system. Transmits results of ID code check of key provided by certification ECU to power source control ECU. Transmits hybrid system start authorization signal to hybrid vehicle control ECU. |
| Transmission Control ECU | Actuates parking lock actuator upon receiving power switch OFF signal from power source control ECU. Transmits state of parking lock operation (whether shift position is P or other position) to power source control ECU. |
| Hybrid Vehicle Control ECU | Starts hybrid system upon receiving system start signal from power source control ECU (ON (READY)). Receives hybrid system start authorization signal from transponder key ECU. |
| Main Body ECU | Transmits body control system signals (courtesy switch, door key lock/unlock switch, door lock position switch, halfway switch signals, etc.) to certification ECU via BEAN. Receives door lock/unlock request signal from certification ECU via dedicated serial communication line (with local protocol), which is used between main body ECU, certification ECU and door control receiver. |
| SYSTEM FUNCTION |
Entry unlock
| Mode | Unlock Standby Door | Door to be Unlocked |
| One Door Unlock* | Driver | Driver Door Only |
| One Door Unlock* | Front Passenger | All Doors |
| One Door Unlock* | Back Door | Back Door Only |
| All Door Unlock | Driver | All Doors |
| All Door Unlock | Front Passenger | All Doors |
| All Door Unlock | Back Door | All Doors |
| Driver's Door Unlock | Driver | Driver Door Only |
| Driver's Door Unlock | Front Passenger | All Doors |
| Driver's Door Unlock | Back Door | All Doors |

Back door entry unlock

Entry lock

Entry ignition
OFF → ON (ACC) → ON (IG)


Warning function
Warning against the driver taking the key outside the vehicle with the shift position on P:
| Possible results without warning | Vehicle theft or inability to restart hybrid system |
| Detection conditions | If all conditions listed below are met and key ID code check result by room oscillator fails, warning will be issued:
|
| Warning (Key warning light) | Illuminates upon detection and turns OFF if power switch is turned OFF or key ID code check result by indoor electrical key oscillator passes. |
| Warning (buzzer (combination meter)) | Sounds once upon detection. Sounds again if vehicle driven in this state. |
| Warning (wireless door lock buzzer) | Sounds 3 times upon detection and stops if power switch is turned OFF or key ID code check result by indoor electrical key oscillator passes |
Warning against the driver taking the key outside the vehicle while the shift position is not on P:
| Possible results without warning | Vehicle theft or inability to restart hybrid system |
| Detection conditions | If all conditions listed below are met and key ID code check result by indoor electrical key oscillator fails, warning will be issued:
|
| Warning (Key warning light) |
|
| Warning (buzzer (combination meter)) | Sounds continuously upon detection and stops if power switch is turned OFF, shift position is changed to P, or key ID code check result by indoor electrical key oscillator passes |
| Warning (wireless door lock buzzer) | Sounds continuously upon detection and stops if power switch is turned OFF, shift position is changed to P, or key ID code check result by indoor electrical key oscillator passes |
Warning against a passenger taking the key outside the vehicle:
| Possible results without warning | Inability to restart hybrid system |
| Detection conditions | If all conditions listed below are met and key ID code check result by indoor electrical key oscillator fails, warning will be issued:
|
| Warning (Key warning light) | Illuminates upon detection and turns OFF if power switch is turned OFF or key ID code check result by indoor electrical key oscillator passes |
| Warning (buzzer (combination meter)) | Sounds once upon detection. Sounds again if vehicle is driven in this state. |
| Warning (wireless door lock buzzer) | Sounds 3 times upon detection and stops if power switch is turned OFF or key ID code check result by indoor electrical key oscillator passes. |
Warning against operating the entry lock with the hybrid system operating:
| Possible results without warning | Vehicle theft or inability to restart hybrid system |
| Detection conditions | If all conditions listed below are met, key ID code check result by indoor electrical key oscillator fails, and key ID code check by door electrical key oscillator passes, warning will be issued:
|
| Warning (Key warning light) | Illuminates upon detection and turns OFF if power switch is turned OFF or key ID code check result by indoor electrical key oscillator passes |
| Warning (buzzer (combination meter)) | - |
| Warning (wireless door lock buzzer) | Sounds for 2 seconds |
Warning against operating the door lock while the key remains in the vehicle:
| Possible results without warning | Vehicle theft |
| Detection conditions | If all conditions listed below are met and key ID code check result by indoor electrical key oscillator passes, warning will be issued:
|
| Warning (Key warning light) | - |
| Warning (buzzer (combination meter)) | - |
| Warning (wireless door lock buzzer) | Sounds for 2 seconds |
Warning against low battery of the key:
| Possible results without warning | Entry control is suddenly disabled |
| Detection conditions | If condition listed below is met, and certification ECU receives code indicating voltage drop of key battery while indoor electrical key oscillator checks key ID code: The power switch has been turned OFF after 20 or more minutes have elapsed after hybrid system has been started. |
| Warning (Key warning light) | - |
| Warning (buzzer (combination meter)) | Sounds once upon detection |
| Warning (wireless door lock buzzer) | - |
Warning against operating the entry ignition outside the detection area of the indoor electrical key oscillator:
| Possible results without warning | User is confused |
| Detection conditions | If condition listed below is met and key ID code check result by indoor electrical key oscillator fails, warning will be issued: Power switch is pushed |
| Warning (Key warning light) | Illuminates for 5 seconds upon detection |
| Warning (buzzer (combination meter)) | Sounds once upon detection |
| Warning (wireless door lock buzzer) | - |
Warning against operating the door lock while any of the doors is open:
| Possible results without warning | Vehicle theft |
| Detection conditions | If all conditions listed below are met, warning will be issued:
|
| Warning (Key warning light) | - |
| Warning (buzzer (combination meter)) | - |
| Warning (wireless door lock buzzer) | Sounds for 10 seconds and stops when 10 seconds have passed or if any door is closed |
Entry unlock mode selector function

Power saving function
| Condition | Control | Reinstatement Condition |
| Vehicle remains parked for a long time. No response from key for more than 5 days | Extends signal transmission interval |
|
| Vehicle remains parked for a long time. No response from key for more than 14 days | Automatically deactivates smart key system |
|
| Vehicle remains parked for a long time. Key is located in vehicle exterior detection area for longer than 10 minutes | Automatically deactivates smart key system |
|