Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

HINT:
Using the Techstream's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG) and press the Techstream main switch ON.

  3. Read the Data List according to the display on the tester.

    Certification ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    D Touch Sensor
    D-door touch sensor/
    ON or OFF
    ON: Sensor is being touched
    OFF: Sensor is not being touched
    -
    P Touch Sensor
    P-door touch sensor/
    ON or OFF
    ON: Sensor is being touched
    OFF: Sensor is not being touched
    -
    D Trigger SW
    D-door trigger switch/
    ON or OFF
    ON: Lock switch is being pushed
    OFF: Lock switch is not being pushed
    -
    P Trigger SW
    P-door trigger switch/
    ON or OFF
    ON: Lock switch is being pushed
    OFF: Lock switch is not being pushed
    -
    Tr/B-Door Lock
    Trunk/Back-door lock switch/
    ON or OFF
    ON: Back door lock switch is being pushed
    OFF: Back door lock switch is not being pushed
    -
    Key Cancel SW
    Key cancel switch/
    ON or OFF
    ON: Key cancel switch is ON
    OFF: Key cancel switch is OFF
    -
    Key Unlk Wrn SW
    Key unlock warning switch/
    ON or OFF
    ON: Key is in key slot
    OFF: No key is in key slot
    -
    IG SW
    Power switch/
    ON or OFF
    ON: Power switch is ON (IG)
    OFF: Power switch is OFF
    -


PERFORM ACTIVE TEST

HINT:
Performing the Techstream's Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect the Techstream to the DLC3.

  2. Turn the power switch ON (IG) and press the Techstream main switch ON.

  3. Perform the Active Test according to the display on the tester.

    Certification ECU 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    D Transmitter
    Driver side transmitter
    ON / OFF
    -
    P Transmitter
    Front passenger side transmitter
    ON / OFF
    -
    Fr Transmitter
    Indoor electrical key oscillator (front)
    ON / OFF
    -
    In Bdr Trnsmttr
    Back door inner transmitter
    ON / OFF
    -
    BDoor Trnsmttr
    Back door outer transmitter
    ON / OFF
    -
    D Select Sig
    Driver side select
    ON / OFF
    -
    P Select Sig
    Front passenger side select
    ON / OFF
    -