SMART KEY SYSTEM > REGISTRATION |
| 1. DESCRIPTION OF REGISTRATION: PROCEDURE 1 |
Select a mode from the following:
Perform code registration and code erasure according to the flowcharts (see PROCEDURE 2 and 3).
| 2. REGISTRATION OF NEW AND ADDITIONAL ENTRY KEY CODE: PROCEDURE 2 |
Register an entry key code using the Techstream.
| System state | State switching condition | Go to |
| 1. Start | - | - |
| 2. Vehicle should be in the following condition | New registration mode.
| 3. Techstream operation |
| Add mode. Power switch is ON (IG) | ||
| 3. Techstream operation |
| 4. Check if it is new registration or additional registration |
| 4. Check if it is new registration or additional registration | New registration mode (when certification ECU is new). | 6. Key (transmitter) switch operation |
| Add mode (when master key is already registered). | 5. Master key (transmitter) switch operation | |
| 5. Master key (transmitter) switch operation | Press any one of the transmitter's switches.
| 6. Key (transmitter) switch operation |
| 6. Key (transmitter) switch operation (Within 30 seconds) |
| 7. Register other key codes or finish the registration |
| 7. Register other key codes or finish the registration | Register other key codes. Continue registration.
| 5. Master key (transmitter) switch operation |
| Finish the registration. | End |
| 3. ERASURE OF ENTRY KEY CODE: PROCEDURE 3 |
Erase an entry key code using the Techstream.
| System state | State switching condition | Go to |
| 1. Start | - | - |
| 2. Vehicle should be in the following condition | Power switch is ON (IG) | 3. Techstream operation |
| 3. Techstream operation |
| 4. Master key (transmitter) switch operation |
| 4. Master key (transmitter) switch operation | This operation should be performed with already registered master key. Press any one of transmitter's switches. | 5. Techstream operation |
| 5. Techstream operation | After above switch operation, operating tester according to tester screen instructions erases codes except codes of master key used in previous step. | End |