Home › BODY ELECTRICAL › DOOR LOCK › SMART KEY SYSTEM

SMART KEY SYSTEM > Entry Functions do not Operate at All

for Preparation Click here


DESCRIPTION

When the entry functions do not operate at all, it is possible that the certification ECU is malfunctioning or that the wire harness leading to the certification ECU is short-circuited.

WIRING DIAGRAM


B140128E01


INSPECTION PROCEDURE

1.INSPECT FUSE (DOME)
  1. Remove the DOME fuse from the engine room junction block and relay block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (CERTIFICATION ECU- BATTERY AND BODY GROUND)
B079785E01
  1. Disconnect the S11 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    S11-18 (IG) - Body ground
    Power switch OFF
    Below 1 V
    Power switch ON (IG)
    10 to 14 V
    S11-1 (+B1) - Body ground
    Always
    10 to 14 V

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    S11-17 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE CERTIFICATION ECU