Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



CHECK DLC3
The vehicle's ECU uses the ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
B126621E04

Symbols (Terminal No.)
Terminal Description
Condition
Specified Condition
SIL (7) - SG (5)
Bus "+" line
During transmission
Pulse generation
CG (4) - Body ground Chassis ground
Chassis ground
Always
Below 1 Ω
SG (5) - Body ground Signal ground
Signal ground
Always
Below 1 Ω
BAT (16) - Body ground
Battery positive
Always
11 to 14 V
CANH (6) - CANL (14)
CAN bus line
Power switch is OFF*
54 to 69 Ω
CANH (6) - CG (4)
HIGH-level CAN bus line
Power switch is OFF*
200 Ω or higher
CANL (14) - CG (4)
LOW-level CAN bus line
Power switch is OFF*
200 Ω or higher
CANH (6) - BAT (16)
HIGH-level CAN bus line
Power switch is OFF*
6 kΩ or higher
CANL (14) - BAT (16)
LOW-level CAN bus line
Power switch is OFF*
6 kΩ or higher

NOTICE:
*: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the power switch, other switches or the doors.

HINT:
Connect the cable of the Techstream (with CAN VIM) to the DLC3, turn the power switch ON (IG) and attempt to use the Techstream. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the Techstream.
  1. If communication is normal when the Techstream is connected to another vehicle, inspect the DLC3 on the original vehicle.
  2. If communication is still not possible when the Techstream is connected to another vehicle, the problem may be in the Techstream itself. Consult the Service Department listed in the Techstream's instruction


WARNING LIGHT
  1. When a problem occurs in the electric power steering system, the PS warning is indicated on the multi-display and the master warning light on the combination meter comes on to inform the driver of the problem.