Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



CHECK DTC
  1. Connect the Techstream (with CAN VIM) to the DLC3.

  2. Turn the power switch ON (IG).

  3. Turn the Techstream on.

  4. Check for DTCs. Enter the following menus: Chassis / EMPS / Trouble Codes.

  5. Confirm the details of the DTCs (Click here).


CLEAR DTC
  1. Connect the Techstream (with CAN VIM) to the DLC3.

  2. Turn the power switch ON (IG).

  3. Turn the Techstream on.

  4. Clear the DTCs. Enter the following menus: Chassis / EMPS / Trouble Codes.

  5. According to the display on the Techstream, select the trouble code data display with the clear button.