Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > FAIL-SAFE CHART

for Preparation Click here


When a problem occurs in the electronic motor power steering system, the P/S warning is indicated on the multi-display, the master warning light on the combination meter comes on, and steering power assist is stopped, fixed at a particular point, or decreased simultaneously to protect the system.

Electronic power steering system 
DTC No.
Malfunction
Fail-safe
C1511
C1512
C1513
C1514
C1517
Torque sensor malfunction
Power assist stops.
C1524
Motor malfunction
Power assist stops.
C1531
C1532
Power steering ECU malfunction
Power assist stops.
C1533
Temperature sensor malfunction in power steering ECU
Amount of power assist is limited.
C1551
IG power source voltage error
Power assist stops.
C1552
PIG power source voltage error
Power assist stops.
C1554
Power source relay malfunction
Power assist stops.
C1555
Motor relay malfunction
Power assist stops.
U0073
CAN bus malfunction
Amount of power assist is fixed for a speed of 43 mph (70 km/h).
U0121
Skid control ECU communication error
Amount of power assist is fixed for a speed of 43 mph (70 km/h).
-
Extremely high temperature in ECU
Amount of power assist is limited until ECU temperature goes down.
-
Power source voltage drop
Power assist is interrupted, but normal power assist is resumed when voltage returns.

HINT:
Amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In that case, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine idling.