Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1552    PIG Power Supply Voltage Malfunction

DTC    C1554    Power Supply Relay Failure

DTC    C1555    Motor Relay Welding Failure

for Preparation Click here


DESCRIPTION

When a problem occurs in the system, the power source relay (built into the power steering ECU) circuit and the motor relay (built into the power steering ECU) circuit are shut off to stop power assist. It is necessary to replace the ECU when there is a problem in the relay because each relay is built into the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1552
PIG power source voltage error
  1. EPS H-fuse
  2. PIG power source circuit
  3. Power steering ECU
C1554
Power source relay malfunction
  1. EPS H-fuse
  2. PIG power source circuit
  3. Power steering ECU
C1555
Motor relay malfunction
  1. EPS Fuse
  2. PIG power source circuit
  3. Power steering ECU

WIRING DIAGRAM


F100802E02


INSPECTION PROCEDURE

1.INSPECT FUSE (EPS)
  1. Remove the EPS H-fuse from the engine room junction block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
INSPECT FOR SHORT IN ALL COMPONENTS CONNECTED TO FUSE AND REPAIR OR REPLACE THEM IF NEEDED, AND REPLACE FUSE
OK


2.CHECK WIRE HARNESS (POWER STEERING ECU - BODY GROUND)
F046438E12
  1. Disconnect the P7 power steering ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    P7-1 (PIG) - Body ground
    10 to 16 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK WIRE HARNESS (POWER STEERING ECU - BODY GROUND)
F046438E06
  1. Disconnect the P7 power steering ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    P7-2 (PGND) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER STEERING ECU