REPAIR INSTRUCTION > INSPECTION MODE PROCEDURE |
| INSPECTION MODE |
Vehicle conditions
Before activating inspection mode, turn the air conditioning off, start the engine with the selector lever in the P position, and check that the engine stops within several seconds after starting (engine warm up check).
Activate inspection mode and inspect the vehicle. The shift position for each test is as follows:
| Test item | Shift position | Inspection mode |
| Vehicle straight traveling test (side slip inspection) | D | ON or OFF |
| Breaking force test | N | ON or OFF |
| Speedometer test | D | ON |
| Exhaust gas test (idling) | P | ON |
| Headlight test | P | ON or OFF |
Reset inspection mode immediately after completion of the inspection.
Special notes for speedometer test
Depress the accelerator pedal slowly and gradually accelerate the vehicle. Make a measurement.
After the measurement, use the brake pedal to gradually decelerate the vehicle.
Special note for using the chassis dynamometer
Always set an appropriate load before starting the test.
![]() |
Activating inspection mode
Connect the Techstream to the DLC3.
Turn the power switch ON (IG).
Turn the Techstream ON.
Select following menu items: Powertrain / Hybrid Control / Active Test / Inspection Mode -2WD Inspection.
![]() |
Check that the HV system warning light flashes on the multi-information display and the master warning light is illuminated in the combination meter.
Deactivating inspection mode
Turn the power switch OFF.