Components
| Function
|
Key
| - When driver inserts key into key slot, built-in transponder chip transmits ID code signal to transponder key amplifier which is provided in key slot.
- For a vehicle with smart entry system (for door lock), if driver operates power switch with key in driver's possession, key receives signals from oscillators and transmits ID code to door control receiver.
|
Key slot
| - Halfway switch:
Detects whether key is inserted and outputs signal to transponder key ECU.
- Full switch:
Detects whether key is inserted and outputs signal to power source control ECU.
- Transponder key amplifier and coil:
Receives ID code signal from transponder chip which is built into key, and outputs it to transponder key ECU.
- Key interlock solenoid:
Power source control ECU operates this solenoid in accordance with power switch mode and shift position to keep key locked in key slot.
|
Power switch
| - In accordance with shift position and stop light switch's condition, changes power modes in 4 stages as follows: OFF, ON (ACC), ON (IG) and ON (READY).
- Power mode can be determined by illumination / flash / color of power switch indicator. Push button start system malfunctions can also be determined.
|
- IG1 relay
- IG2 relay
- ACC relay
| Operates in accordance with power source control ECU to supply power to respective system.
|
Stop light switch
| Outputs brake pedal's status to power source control ECU.
|
Parking lock actuator
| - Operates in accordance with signals from transmission control ECU to actuate parking lock mechanism.
- Detects actuation status of parking lock (whether shift position is P or other position) and outputs it to transmission control ECU.
|
Power source control ECU
| Controls push button start system in accordance with signals received from switches and ECUs.
|
Transponder key ECU
| - Controls engine immobiliser system by recognizing key ID code transmitted by transponder key amplifier.
- Receives ID code check results from certification ECU*.
- Transmits key ID code check results to power source control ECU.
- Transmits hybrid control system start authorization signal to hybrid vehicle control ECU.
|
Transmission control ECU
| - Actuates parking lock actuator upon receiving power switch OFF signal from power source control ECU.
- Transmits actuation status of parking lock (whether shift position is P or other position) to power source control ECU.
|
Hybrid vehicle control ECU
| - Starts hybrid control system in accordance with system start signal received from power source control ECU.
- Receives hybrid control system start authorization signal from transponder key ECU.
|
Certification ECU*
| Checks ID code received from door control receiver and transmits check results to transponder key ECU.
|
Control
| Outline
|
Power switch control (w/o smart key system (for door lock))
| Transponder key ECU checks ID code when key is inserted into key slot. Power source control ECU verifies check results and authorizes operation of switch.
|
Power switch control (w/ smart key system (for door lock))
| - When driver operates power switch with key in driver's possession, power source control ECU starts indoor electrical key oscillator, which transmits request signal to key. Upon receiving this signal, key transmits ID code signal to certification ECU.
- Transponder key ECU verifies check results received from certification ECU via BEAN and sends them to power source control ECU. Based on these results, power source control ECU authorizes operation of power switch.
|
Auto P control
| While shift position is not P, if power switch is turned OFF, hybrid vehicle control ECU commands transmission control ECU to activate parking lock actuator and change shift position to P.
|
Diagnosis
| When power source control ECU detects malfunction, power source control ECU diagnoses and memorizes malfunction.
|