Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

SMART KEY SYSTEM > SYSTEM DIAGRAM

for Preparation Click here



B128116E01


Sender
Receiver
Signal
Line
Hybrid vehicle control ECU
Power source control ECU
  1. Shift position signal (power source control)
  2. Drive OK signal (power stop control)
  3. Stop switch signal (power source control)
BEAN
Meter
Power source control ECU
Vehicle speed signal (power source control)
BEAN
Body ECU
Power source control ECU
  1. Diagnosis erasure
  2. Diagnostic tool request
  3. Door lock position signal (driver, passenger and rear doors) (power switch illumination control)
  4. Courtesy switch signal (driver, passenger and rear doors) (power switch illumination control)
  5. Vehicle model signal (power source control switch)
  6. IG switch signal (power source control)
  7. ACC switch signal (power source control)
  8. Key switch signal (key lock control)
  9. Fading dome light illumination request signal (power switch illumination control)
  10. Taillight illumination signal (power switch illumination control)
  11. All doors courtesy switch signal (power switch illumination control)
BEAN
Steering lock ECU
Power source control ECU
Immobiliser information signal (power source control)
BEAN
Power source control ECU
Body ECU
Power switch signal (for security cancel)
BEAN
Power source control ECU
Steering lock ECU
  1. Immobiliser ID match request signal (ID match start at power ON)
  2. Key insertion status signal (for immobiliser control)
BEAN
Transmission control ECU
Power source control ECU
  1. P status signal (key interlock control)
  2. P control ECU malfunctioning status signal (power source control, key lock control)
  3. Auto P cancel signal (power source control, key lock control)
  4. NP status signal (power source control, key lock control)
  5. Auto P OK signal (power source control, key lock control)
BEAN
Certification ECU
Power source control ECU
  1. Immobiliser ID match request signal (smart ignition control)
  2. Key insertion status signal (smart ignition control)
  3. Key code confirmation signal (wireless control)
BEAN
Theft warning ECU
Power source control ECU
Power switch signal (for security set and cancel)
BEAN
Power source control ECU
Transmission control ECU
Power source OFF ready signal (power source AUTO OFF control)
BEAN