Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2271    Ignition Hold Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when the IG output circuits inside the power source control ECU are open or short.

DTC No.
DTC Detection Condition
Trouble Area
B2271
Hold circuit, IG1 relay actuation circuit or IG2 relay actuation circuit inside power source control ECU is open or short
  1. Power source control ECU
  2. AM1 fuse
  3. AM2 fuse
  4. Wire harness

WIRING DIAGRAM


B128115E01


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Delete the DTC (Click here).

  1. Check for DTCs again.

    OK:
    No DTC is output.



OK
END
NG


2.INSPECT FUSE (AM1, AM2)
  1. Remove the AM1 fuse from the driver side junction block.

  1. Remove the AM2 fuse from the engine room junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK WIRE HARNESS (POWER SOURCE CONTROL ECU - BATTERY)


    B079748E03
  1. Disconnect the P6 ECU connector.

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    P6-33 (AM1) - Body ground
    10 to 14 V
    P6-12 (AM2) - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER SOURCE CONTROL ECU