Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2272    Ignition 1 Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a malfunction is occurring in the IG output circuit, which is from the IG1 relay actuation circuit inside the power source control ECU to the IG1 relay.

DTC No.
DTC Detection Condition
Trouble Area
B2272
IG1 relay actuation circuit inside power source control ECU or other related circuit is malfunctioning
  1. Power source control ECU
  2. IG1 relay
  3. Wire harness

WIRING DIAGRAM


B135511E01


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (IG1 RELAY)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press Techstream main switch ON.

  1. Select the items below in the DATA LIST and read the displays on Techstream.

    Power source control ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG1 Relay Monitor (Outside)
    IG1 outer relay monitor /
    ON or OFF
    ON: Power switch ON (IG)
    OFF: Power switch OFF
    -

    OK:
    ON (power switch ON (IG)) appears on the screen.



OK
REPLACE POWER SOURCE CONTROL ECU
NG


2.INSPECT IG1 RELAY


    B112776E02
  1. Remove the IG1 relay from the driver side junction block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)



NG
REPLACE IG1 RELAY
OK


3.CHECK WIRE HARNESS (DRIVER SIDE JUNCTION BLOCK - ECU AND BODY GROUND)


    B128121E01
  1. Disconnect the 1J and 1E driver side junction block connectors.

  1. Disconnect the P6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    1J-3 - P6-34 (IG1D)
    Below 1 Ω
    1J-3 or P6-34 (IG1D) - Body ground
    10 kΩ or higher
    1E-17 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.CHECK DRIVER SIDE JUNCTION BLOCK


    B135432E01
  1. Remove the IG1 relay from the driver side junction block.

  1. Disconnect the 1J and 1E driver side junction block connectors.

  1. Measure the resistance of the driver side junction block.

    Standard resistance:
    Tester Connection
    Specified Condition
    1J-3 - Driver side junction block IG1 relay terminal 2
    Below 1 Ω
    1E-17 - Driver side junction block IG1 relay terminal 1
    Below 1 Ω



NG
REPLACE DRIVER SIDE JUNCTION BLOCK ASSEMBLY
OK

REPLACE POWER SOURCE CONTROL ECU