Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2273    Ignition 2 Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a malfunction is occurring in the IG output circuit, which is from the IG2 relay actuation circuit inside the power source control ECU to the IG2 relay.

DTC No.
DTC Detection Condition
Trouble Area
B2273
IG2 relay actuation circuit inside power source control ECU or other related circuit is malfunctioning
  1. Power source control ECU
  2. Wire harness

WIRING DIAGRAM


B135510E01


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (IG2 RELAY)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press Techstream main switch ON.

  1. Read the DATA LIST according to the displays on the tester.

    Power source control ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG2 Relay Monitor (Inside)
    IG2 inner relay monitor /
    ON or OFF
    ON: Power switch ON (IG)
    OFF: Power switch OFF
    -

    OK:
    ON (power switch ON (IG)) appears on the screen.



OK
REPLACE POWER SOURCE CONTROL ECU
NG


2.CHECK WIRE HARNESS (ENGINE ROOM JUNCTION BLOCK - ECU AND BODY GROUND)


    B080046E01
  1. Disconnect the 3I junction block connector.

  1. Disconnect the P6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    3I-2 - P6-35 (IG2D)
    Below 1 Ω
    3I-3 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK ENGINE ROOM RELAY BLOCK


    B080053E01
  1. Disconnect the 3I and 3K junction block connectors.

  1. Measure the resistance of the junction block connectors.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3K-1 - 3I-4
    When battery voltage is not applied to terminals 3I-2 and 3I-3
    10 kΩ or higher
    3K-1 - 3I-4
    When battery voltage is applied to terminals 3I-2 and 3I-3
    Below 1 Ω



NG
REPLACE ENGINE ROOM RELAY BLOCK
OK

REPLACE POWER SOURCE CONTROL ECU