Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2274    ACC Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a malfunction is occurring in the ACC output circuit, which is from the ACC relay actuation circuit inside the power source control ECU to the ACC relay.

DTC No.
DTC Detection Condition
Trouble Area
B2274
ACC relay actuation circuit inside power source control ECU or other related circuit is malfunctioning
  1. Power source control ECU
  2. ACC relay
  3. Wire harness

WIRING DIAGRAM


B128110E01


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (ACC RELAY)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press Techstream main switch ON.

  1. Read the DATA LIST according to the displays on the tester.

    Power source control ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ACC Relay Monitor
    ACC relay monitor /
    ON or OFF
    ON: Power switch ON (ACC)
    OFF: Power switch OFF
    -

    OK:
    ON (power switch ON (ACC)) appears on the screen.



OK
REPLACE POWER SOURCE CONTROL ECU
NG


2.INSPECT ACC RELAY


    B060778E74
  1. Remove the ACC relay.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)



NG
REPLACE ACC RELAY
OK


3.CHECK WIRE HARNESS (ACC RELAY - POWER SOURCE CONTROL ECU AND BODY GROUND)


    B128118E01
  1. Remove the ACC relay.

  1. Disconnect the P6 connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    A12-1 - P6-11 (ACCD)
    Below 1 Ω
    A12-2 - Body ground
    Below 1 Ω
    A12-1 or P6-11 (ACCD) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER SOURCE CONTROL ECU