Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2275    STSW Monitor Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when the ST output circuits inside the power source control ECU is open or short.

DTC No.
DTC Detection Condition
Trouble Area
B2275
ST output circuit inside power source control ECU or other related circuit is malfunctioning
  1. Power source control ECU
  2. Hybrid vehicle control ECU
  3. Wire harness

WIRING DIAGRAM


B128114E01


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Delete the DTC (Click here).

  1. Check for DTCs again.

    OK:
    No DTC is output.



OK
END
NG


2.CHECK WIRE HARNESS (POWER SOURCE CONTROL ECU - HYBRID VEHICLE CONTROL ECU)


    B128123E01
  1. Disconnect the P6 and H14 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    P6-39 (STSW) - H14-5 (ST2)
    Below 1 Ω
    P6-39 (STSW) or H14-5 (ST2) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK OPERATION OF POWER SOURCE CONTROL ECU
  1. After replacing the power source control ECU with a normally functioning ECU, check that the hybrid control system can start normally.

    OK:
    Hybrid control system can start normally.



NG
GO TO HYBRID CONTROL SYSTEM
OK

NORMAL (POWER SOURCE CONTROL ECU DEFECTIVE)