Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2278    Engine Switch Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when 1) a malfunction is detected between the power source control ECU and the power switch; or 2) either of the switches inside the power switch is malfunctioning.

DTC No.
DTC Detection Condition
Trouble Area
B2278
Communication is abnormal between power source control ECU and power switch; or power switch is defective
  1. Power source control ECU
  2. Power switch
  3. Wire harness

WIRING DIAGRAM


B128111E01


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (START SWITCH 1 and 2)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press Techstream main switch ON.

  1. Read the DATA LIST according to the displays on the tester.

    Power source control ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Start Switch1
    Start Switch 1 /
    ON or OFF
    ON: Power switch ON (IG)
    OFF: Power switch OFF
    -
    Start Swtich2
    Start Switch 2 /
    ON or OFF
    ON: Power switch ON (IG)
    OFF: Power switch OFF
    -

    OK:
    ON (power switches 1 and 2 are ON (IG)) appears on the screen



OK
REPLACE POWER SOURCE CONTROL ECU
NG


2.CHECK WIRE HARNESS (POWER SWITCH - POWER SOURCE CONTROL ECU AND BODY GROUND)


    B128120E03
  1. Disconnect the P11 power switch connector.

  1. Disconnect the P6 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    P11-5 (SS1) - P6-14 (SSW1)
    Below 1 Ω
    P11-7 (SS2) - P6-37 (SSW2)
    Below 1 Ω
    P11-6 (GND) - Body ground
    Below 1 Ω
    P11-5 (SS2) or P6-14 (SSW1) - Body ground
    10 kΩ or higher
    P11-7 (SS2) or P6-37 (SSW2) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.INSPECT POWER SWITCH


    B080048E03
  1. Remove the power switch.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (SS2) - 6 (GND)
    Pushed
    Below 1 Ω
    5 (SS1) - 6 (GND)
    Pushed
    Below 1 Ω
    7 (SS2) - 6 (GND)
    Released
    10 kΩ or higher
    5 (SS1) - 6 (GND)
    Released
    10 kΩ or higher



NG
REPLACE POWER SWITCH
OK

REPLACE POWER SOURCE CONTROL ECU