Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2281    "P" Signal Malfunction

for Preparation Click here


DESCRIPTION

The power source control ECU and the transmission control ECU are connected by a cable and the BEAN. If the cable information and BEAN information are inconsistent, this DTC will be output.

DTC No.
DTC Detection Condition
Trouble Area
B2281
Cable and BEAN between power source control ECU and transmission control ECU are inconsistent
  1. Power source control ECU
  2. Transmission control ECU
  3. Wire harness

WIRING DIAGRAM


B128114E02


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (SHIFT P SIGNAL)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press Techstream main switch ON.

  1. Read the DATA LIST according to the displays on the tester.

    Power source control ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Shift P Signal
    Shift P Signal /
    ON or OFF
    ON: Shift P signal ON (Shift position is P)
    OFF: Shift P signal OFF (Shift position is not P)
    -

    OK:
    "ON" (P signal is ON) appears on the screen.



OK
REPLACE POWER SOURCE CONTROL ECU
NG


2.CHECK WIRE HARNESS (POWER SOURCE CONTROL ECU - TRANSMISSION CONTROL ECU)


    B128122E01
  1. Disconnect the P6 and T4 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    P6-5 (P) - T4-8 (PPOS)
    Below 1 Ω
    P6-5 (P) or T4-8 (PPOS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK OPERATION OF POWER SOURCE CONTROL ECU
  1. After replacing the power source control ECU with a normally functioning ECU, check that the hybrid control system can start normally.

    OK:
    Hybrid control system can start normally.



NG
GO TO SHIFT CONTROL SYSTEM
OK

NORMAL (POWER SOURCE CONTROL ECU DEFECTIVE)