Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2284    Brake Signal Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when: 1) the brake signal circuit between the power source control ECU and the stop light switch is malfunctioning, and 2) the BEAN information is inconsistent.

DTC No.
DTC Detection Condition
Trouble Area
B2284
Communication or communication line is abnormal between power source control ECU and stop light switch
  1. Power source control ECU
  2. Stop light switch
  3. Wire harness

WIRING DIAGRAM


B128109E01


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (STOP LIGHT SWITCH)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press Techstream main switch ON.

  1. Read the DATA LIST according to the displays on the tester.

    Power source control ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Stop Light Switch1
    Stop light switch 1 /
    ON or OFF
    ON: Brake pedal depressed
    OFF: Brake pedal released
    -

    OK:
    ON (brake pedal depressed) appears on the screen.



OK
REPLACE POWER SOURCE CONTROL ECU
NG


2.CHECK WIRE HARNESS (STOP LIGHT SWITCH - POWER SOURCE CONTROL ECU AND BATTERY)


    B080047E01
  1. Disconnect the S16 switch connector.

  1. Disconnect the P6 ECU connector.

  1. Measure the resistance and voltage of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    S16-1 - P6-1 (STP)
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Specified Condition
    S16-2 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.INSPECT STOP LIGHT SWITCH ASSEMBLY


  1. Remove the stop light switch.


    E130045E01

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Switch pin not pushed
    Below 1 Ω
    3 - 4
    Switch pin not pushed
    10 kΩ or higher
    1 - 2
    Switch pin pushed
    10 kΩ or higher
    3 - 4
    Switch pin pushed
    Below 1 Ω



NG
REPLACE STOP LIGHT SWITCH ASSEMBLY
OK

REPLACE POWER SOURCE CONTROL ECU