Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2286    Ready Signal Malfunction

for Preparation Click here


DESCRIPTION

The power source control ECU and the hybrid vehicle control ECU are connected by a cable and the BEAN. If the cable information and BEAN information are inconsistent, this DTC will be output.

DTC No.
DTC Detection Condition
Trouble Area
B2286
Cable and BEAN information between power source control ECU and hybrid vehicle control ECU are inconsistent
  1. Power source control ECU
  2. Hybrid vehicle control ECU
  3. Wire harness

WIRING DIAGRAM


B128114E04


INSPECTION PROCEDURE

1.READ VALUE OF DATA LIST (READY SIGNAL)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and press Techstream main switch ON.

  1. Read the DATA LIST according to the displays on the tester.

    Power source control ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Ready Signal
    Ready signal /
    ON or OFF
    ON: Power switch ON (READY)
    OFF: Power switch OFF or ON (IG) or ON (ACC)
    -

    OK:
    ON (power switch is ON (READY)) appears on the screen.



OK
REPLACE POWER SOURCE CONTROL ECU
NG


2.CHECK WIRE HARNESS (POWER SOURCE CONTROL ECU - HYBRID VEHICLE CONTROL ECU)


    B128123E02
  1. Disconnect the P6 and H14 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    P6-22 (RDY) - H14-28 (RDY)
    Below 1 Ω
    P6-22 (RDY) or H14-28 (RDY) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.CHECK OPERATION OF POWER SOURCE CONTROL ECU
  1. After replacing the power source control ECU with a normally functioning ECU, check that the hybrid vehicle control system can start normally.

    OK:
    Hybrid vehicle control system can start normally.



NG
GO TO HYBRID CONTROL SYSTEM
OK

NORMAL (POWER SOURCE CONTROL ECU DEFECTIVE)