Home › ENGINE › 1NZ-FXE STARTING › SMART KEY SYSTEM

DTC    B2287    LIN Communication Master Malfunction

DTC    B2289    Key Collation Waiting Time Over

for Preparation Click here


DESCRIPTION

This DTC is output when: 1) any other DTC is set in the power source control ECU; or 2) the wire harness between the power source control ECU and the transponder key ECU is open or short.

DTC No.
DTC Detection Condition
Trouble Area
B2287
Communication or communication line is abnormal between power source control ECU and transponder key ECU
  1. Power source control ECU
  2. Transponder key ECU
  3. Wire harness
B2289
Either condition below is met:
  1. Cable and BEAN are abnormal between power source control ECU and immobiliser system
  2. Immobiliser system is malfunctioning
  1. Power source control ECU
  2. Engine immobiliser system
  3. Wire harness

WIRING DIAGRAM


B128114E05


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (POWER SOURCE CONTROL ECU - TRANSPONDER KEY ECU)


    B128122E02
  1. Disconnect the P6 and T5 ECU connectors.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    P6-30 (LIN1) - T5-14 (LIN1)
    Below 1 Ω
    P6-30 (LIN1) or T5-14 (LIN1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


2.CHECK OPERATION OF POWER SOURCE CONTROL ECU
  1. After replacing power source control ECU with a normally functioning ECU, check that the hybrid control system can start normally.

    Result 
    Result
    Proceed to
    Hybrid system can start normally
    A
    Hybrid system cannot start (w/ smart key system (for door lock))
    B
    Hybrid system cannot start (w/o smart key system (for door lock))
    C



B
GO TO ENGINE IMMOBILISER SYSTEM (w/ SMART KEY SYSTEM)

C
GO TO ENGINE IMMOBILISER SYSTEM (w/o SMART KEY SYSTEM)
A

NORMAL (POWER SOURCE CONTROL ECU DEFECTIVE)