ELECTRONIC SHIFT LEVER SYSTEM > SYSTEM DESCRIPTION |
| SYSTEM DESCRIPTION |
| FUNCTION OF EACH COMPONENT |
| Parts name | Function |
| Shift Control Actuator |
|
| Transmission Control ECU |
|
| Parking Lock Mechanism | The parking lock pawl rotates according to the movement of the parking lock rod when the parking lock motor rotates, and engages with the parking gear on the transaxle side, causing the parking lock mechanism to lock or unlock. |
| Hybrid Vehicle Control ECU | This ECU sends a P lock or P unlock demand signal to the transmission control ECU based on information from the selector lever and the P position switch. |
| Power Source Control ECU | This ECU sends a signal with power off information to the transmission control ECU. The transmission control ECU then sends the signal to the hybrid vehicle control ECU. |
| P Position Switch Indicator Light | This light comes on/goes off to indicate the P lock/unlock status and blinks to indicate a malfunction in the electronic shift lever system. |
| Combination Meter | A malfunction in the transmission control ECU is indicated by the illumination of the master warning light on the combination meter. |
| Multi-display | A malfunction in the transmission control ECU is indicated on the multi-display. |
| OPERATION DESCRIPTION |
![]() |
Operation to switch to the P position:
When the P position switch is turned on to activate parking lock, a signal is sent to the hybrid vehicle control ECU.
The hybrid vehicle control ECU determines whether "P lock" is possible or not based on this signal and other vehicle information.
If the hybrid vehicle control ECU determines that "P lock" is possible, it sends a "P lock" operation demand signal to the transmission control ECU.
![]() |
After receiving the signal, the transmission control ECU activates the shift control actuator in order to lock the parking lock mechanism, and turns on the P position switch indicator light.
The transmission control ECU controls motor rotation angle based on signals from the rotation angle sensor in the shift control actuator.
![]() |
![]() |
Operation to switch to a non-P position:
When the hybrid system is started (the vehicle is ready to be driven) and the selector lever is moved to the R, N, or the D position with the brake pedal depressed, a signal is sent to the hybrid vehicle control ECU.
This signal is then sent from the hybrid vehicle control ECU to the transmission control ECU as a "P lock release" operation demand signal.
![]() |
After receiving the signal, the transmission control ECU activates the shift control actuator in order to unlock the parking lock mechanism, and turns off the P position switch indicator light.
The transmission control ECU controls motor rotation angle based on signals from the rotation angle sensor in the shift control actuator.
| SHIFT POSITION CHANGE FUNCTION |
The electronic shift lever system comprehensively determines vehicle conditions and changes the shift position, as shown in the following chart, by cooperating with the shift control function of the hybrid system (except when the reject function, described later, is in operation).
Other than indicated in the following chart, when the power switch is turned OFF with the vehicle stopped, the shift position is automatically changed to the P position.

| REJECT FUNCTION |
In the electronic shift lever system, there may be a situation in which a shift change cannot be done for safety reasons. When attempting to move the selector lever in such a situation, the system sounds a reject buzzer inside the meter and changes the shift position as shown in the following table.
| Shift operation which causes reject function to operate | Shift position after rejection |
| Shifting from the P position without depressing the brake pedal | Held in the P position |
| Shifting to the P position while driving | Changed to the N position |
| Shifting between forward and reverse positions while driving | Changed to the N position |
| Shifting to the B position from the position other than D | Changed to the N position |